PROCEDURE FOR TRAVERSE (TSM)

1) Before starting doing a traverse, a starting point/base line must be set up.

2) To start, by using TSM software click on Starting Point and then click on any point on the PDUK

3) This table should be appeared

TSM Figure

You may click ok to proceed and then choose what type of mark for the point.

And the point that have been choose will be point 1

Determining Datum Line

• Click on icon Base Line and then click the starting point

• Click capture and make sure that there was a connection between the total station and toughbook. A “CL to target” window will display will appear and click ok. Do the same for CR.

• After the observation has been made, click save and insert, Mark desc. The datum line will be in green colour.